Creaform and Camoplast: Jig Control During Production

Camoplast’s Polymer Solutions group is a leading provider of thermoplastics and Thermoset systems, as well as components for premium manufacturers and motor vehicle OEMs. Camoplast’s Roxton Falls division was looking for a quality control solution for its drilling jigs during production to ensure compliance on a regular basis.

Camoplast’s objectives:

• Control jig bending and wear
• Target potential bending areas caused by production forces
• Detect drilling issues at the source of the problem
• Minimize part inspection costs and timeframes
• Avoid transportation between production and metrology sites

Challenges:

• Very short turnarounds (measures are taken during 15- and 30-minute breaks in the course of a non-stop, 24-hour production cycle)
• Need for accurate and quick results
• Harsh conditions (dust, heat and limited space)

Creaform’s answer

To discover how Creaform solved the case, read the complete story!!